Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
04/09/08 21:10
Read: times


 		 #153094 - Try again.
Responding to: ???'s previous message
Mauro,

It is very important to do the correct sequence.

1. disconnect USB
2. hardware condition on 5131. Vcc = 3.3V
3. connect USB
4. Found new Hardware
5. Install driver
6. Run Flip.

Believe me, I struggled for ages to get this running. Follow the steps exactly, and it works.

When driver is installed, Flip works very nicely.

David.

List of 27 messages in thread
TopicAuthorDate
usb driver to use at89c5131            01/01/70 00:00      
   AT89C5131 recognised by FLIP            01/01/70 00:00      
      No recognized yet. "Help please"            01/01/70 00:00      
         No programmer needed.            01/01/70 00:00      
            I just remember            01/01/70 00:00      
            hardware contition            01/01/70 00:00      
               USB device driver            01/01/70 00:00      
            schematic            01/01/70 00:00      
               Email schematic            01/01/70 00:00      
         Did you apply 5V to a 3.3V part?            01/01/70 00:00      
            AT89C5131A-S3SUM-ND is 2.7V - 5.5V            01/01/70 00:00      
               AT89C5131A-UM            01/01/70 00:00      
   Device Manager            01/01/70 00:00      
      Use driver that comes with your FLIP 3.3.1            01/01/70 00:00      
         USB Driver            01/01/70 00:00      
            Try again.            01/01/70 00:00      
               It is finished!            01/01/70 00:00      
                  Pleased that everything works OK now.            01/01/70 00:00      
                     Extended Range            01/01/70 00:00      
                        My AT89C5131-IL does not do correct Vref            01/01/70 00:00      
                           I guess you are led astary or confused            01/01/70 00:00      
                              Thanks Eric. That explains it.            01/01/70 00:00      
   AT89C51RC2 Bootloader process            01/01/70 00:00      
      Just check the box in FLIP            01/01/70 00:00      
         I have already done it            01/01/70 00:00      
            That is what it is supposed to do. Flip manual            01/01/70 00:00      
               Ok            01/01/70 00:00      

Back to Subject List