Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
04/01/08 19:22
Read: times


 		 #152856 - usb driver to use at89c5131
I am using the USB interface for ISP programming of AT89C5131A-M now.
But still I have not obtained any success.

Every time I plug-in my board in the USB port of the computer, the following message is displayed

"USB Device Not Recognized"

It is detected but Windows does not recognize it.
It is not an Atmel kit for programming and Flip 3.1.1 is what I want to use for ISP programming.
Is the USB driver my problem? I need to install a driver like JUNGO one?
Any suggestion will be grateful!! And i beg your pardon about my bad english-
Thanks
Mauro




List of 27 messages in thread
TopicAuthorDate
usb driver to use at89c5131            01/01/70 00:00      
   AT89C5131 recognised by FLIP            01/01/70 00:00      
      No recognized yet. "Help please"            01/01/70 00:00      
         No programmer needed.            01/01/70 00:00      
            I just remember            01/01/70 00:00      
            hardware contition            01/01/70 00:00      
               USB device driver            01/01/70 00:00      
            schematic            01/01/70 00:00      
               Email schematic            01/01/70 00:00      
         Did you apply 5V to a 3.3V part?            01/01/70 00:00      
            AT89C5131A-S3SUM-ND is 2.7V - 5.5V            01/01/70 00:00      
               AT89C5131A-UM            01/01/70 00:00      
   Device Manager            01/01/70 00:00      
      Use driver that comes with your FLIP 3.3.1            01/01/70 00:00      
         USB Driver            01/01/70 00:00      
            Try again.            01/01/70 00:00      
               It is finished!            01/01/70 00:00      
                  Pleased that everything works OK now.            01/01/70 00:00      
                     Extended Range            01/01/70 00:00      
                        My AT89C5131-IL does not do correct Vref            01/01/70 00:00      
                           I guess you are led astary or confused            01/01/70 00:00      
                              Thanks Eric. That explains it.            01/01/70 00:00      
   AT89C51RC2 Bootloader process            01/01/70 00:00      
      Just check the box in FLIP            01/01/70 00:00      
         I have already done it            01/01/70 00:00      
            That is what it is supposed to do. Flip manual            01/01/70 00:00      
               Ok            01/01/70 00:00      

Back to Subject List