Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Thread Closed: Thread will re-open when original poster replies

???
06/13/07 08:14
Read: times


 		 #140647 - 10MHz clock from 8051
Responding to: ???'s previous message
See this post:
http://www.8052.com/forum/read.phtml?id=140494

So you can put a gate like AC and get same clock as crystal
from X2 pin.
I suppose that only clock reqd and not synchronous data.

That can be done with those uCs with about 100Mhz clock and
single instruction cycle.

List of 28 messages in thread
TopicAuthorDate
10mhz clock from 8051 cpu            01/01/70 00:00      
   BARELY possible ...            01/01/70 00:00      
      Ten milli hertz - that's a doddle!            01/01/70 00:00      
         SynMOS            01/01/70 00:00      
            what's MIP?            01/01/70 00:00      
            What, exactly, do you mean?            01/01/70 00:00      
      if you don't mind WHICH pin it is...            01/01/70 00:00      
         I think he does            01/01/70 00:00      
            well if that data does not need to change...            01/01/70 00:00      
               how are you going to get the data to "any pin"            01/01/70 00:00      
                  one instruction cycle            01/01/70 00:00      
                  DS89C4x0 might manage it            01/01/70 00:00      
                     let's have a 'yellow light'            01/01/70 00:00      
   graphical display            01/01/70 00:00      
      so you do NOT need just a clock            01/01/70 00:00      
         10MHz clock from 8051            01/01/70 00:00      
            Consider what you\'re doing.            01/01/70 00:00      
               SiLabs F120            01/01/70 00:00      
                  Are you certain that applies?            01/01/70 00:00      
                     I specifically did not            01/01/70 00:00      
                        that's true ...            01/01/70 00:00      
                           then why7 the ^&%$&^(* are we discussing that?            01/01/70 00:00      
                              You're absolutely right, Erik ... We need input.            01/01/70 00:00      
               nonsense?            01/01/70 00:00      
                  Little nonsense is better            01/01/70 00:00      
                     not 'a little' but 'utter' nonsense            01/01/70 00:00      
                     interrupt latency            01/01/70 00:00      
                        Maarten, you are correct            01/01/70 00:00      

Back to Subject List