Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
03/12/07 11:11
Modified:
  03/12/07 11:22

Read: times


 
#134752 - testing and troubleshooting
Responding to: ???'s previous message
Test your programs output with a connection to PC serial port and Hyperterminal (or any other terminal emulator program).


Does your 8051 send out what think it needs to send out?

If you connect your pc to the MC35, and by means of your PC , you emulate your 8051, does the MC35 react as supposed?

Doe she send anything at all?


You can't write a serial comms program, hook it up to a device and then expect everything to work as you think it should work. You have made assuptions when writing your program (ie the MC35 responds by "OK"). You need to verify your assumptions.

Do not try to run before you can walk. Don't walk before you ca crawl...


Is your connection correct? I can't say. Is the MC35 a DCE or DTE?

Use your PC to determine what needs to be connected

Regards

Patrick


List of 27 messages in thread
TopicAuthorDate
[Help] AT89C51 with GSM MC35i terminal problem            01/01/70 00:00      
   testing and troubleshooting            01/01/70 00:00      
      Simulated using 8051IDE            01/01/70 00:00      
   RTFM!            01/01/70 00:00      
   MC35i or MC35i Terminal?            01/01/70 00:00      
      Not entirely true            01/01/70 00:00      
      It is Siemens MC35i terminal            01/01/70 00:00      
         Wrong connections            01/01/70 00:00      
            What is IGT?            01/01/70 00:00      
               IGT            01/01/70 00:00      
                  power supply?            01/01/70 00:00      
                     Stop!!            01/01/70 00:00      
                     Providing IGT            01/01/70 00:00      
                        Right            01/01/70 00:00      
                           I'm done with it.            01/01/70 00:00      
                     Manual reading time            01/01/70 00:00      
                        Must add the 2 more signal            01/01/70 00:00      
                           No, that's not right            01/01/70 00:00      
                              MC35i was siemens GSM modem module            01/01/70 00:00      
                                 Pardon??            01/01/70 00:00      
   baudrate 9600?            01/01/70 00:00      
      Not necessarily            01/01/70 00:00      
          m35i with uC..            01/01/70 00:00      
   I think ur using wrong baud rate            01/01/70 00:00      
      Wrong            01/01/70 00:00      
         Andy Neil is really someone            01/01/70 00:00      
            Nearly            01/01/70 00:00      

Back to Subject List