| ??? 03/02/06 11:11 Read: times |
#111056 - Reply to Russell Responding to: ???'s previous message |
Dear Russell,
Problem is that, when i powered On my cct. it works fine and according to my program. Display changes its valus if i vary the RH range exposed to the sensor ie. vary the analog signal in put to the ADC. But sometimes when i powered on the cct. the display is showing nothing or display shows some character like $/& etc. Every time i power off and on again , it may show the right display or erronious display (completely unpredictable). I can't understand where i made the mistake. Thanks. Kaushik. |
| Topic | Author | Date |
| Regarding the LCD display problem | 01/01/70 00:00 | |
| Code i used | 01/01/70 00:00 | |
| overflowcount++; | 01/01/70 00:00 | |
| Detail about my aim. | 01/01/70 00:00 | |
| Main | 01/01/70 00:00 | |
| Rep: Ian | 01/01/70 00:00 | |
| Reset ? | 01/01/70 00:00 | |
| MC working after the reset | 01/01/70 00:00 | |
| So where's the problem? | 01/01/70 00:00 | |
| Reply to Russell | 01/01/70 00:00 | |
| Reset system | 01/01/70 00:00 | |
| Could be bad LCD Reset. | 01/01/70 00:00 | |
| LCD resets | 01/01/70 00:00 | |
| Rep: Prahlad Purohit | 01/01/70 00:00 | |
Yes you need a supervisor. | 01/01/70 00:00 |