| ??? 02/10/06 12:33 Read: times |
#109692 - 2 Level Master Slave architecture |
Dear All,
1) I am going to develop a system, Using RS485,It is all about the data acquistion.As Rs485 only Support 32 Receiver /Drivers. But intended system is for +200 terminals. Do you have any trick or alternative to make the network.. 2) iS 2-level Master Slave Architecture is need for desired system to make an network or RS 485 is sufficient to connect. A 2051 Microcontroller is being used on each terminal to count the RPM or each station.I want to show the RPM of 200 station on a PC Monitor attached with Master Microcontroller. Thanks Moizi New Entry.... Really wonderful place, this site is... |
| Topic | Author | Date |
| 2 Level Master Slave architecture | 01/01/70 00:00 | |
| not correct | 01/01/70 00:00 | |
| latency | 01/01/70 00:00 | |
| that depends ... | 01/01/70 00:00 | |
| 32+32+... | 01/01/70 00:00 | |
| a current hog | 01/01/70 00:00 | |
| branches | 01/01/70 00:00 | |
| unit Load........ | 01/01/70 00:00 | |
Forget about resistance etc think ULs on | 01/01/70 00:00 |