| ??? 01/27/06 09:02 Read: times |
#108484 - more on relay ratings Responding to: ???'s previous message |
Farshid Jafari Harandi said:
You can switch every load by the contacts as far as you don't violate the contacts rating.So if you want to switch a mains light rated at 4 Amp I suggest you to go for a relay with 240V and 10 Amp rating. Note that some relays specifically state different ratings for inductive & resistive loads. When switching incandescent lamp loads, you also have to beware of the initial "inrush" current surge... (again, some relays will specifically state an incandescent lamp rating). |
| Topic | Author | Date |
| Relay board diagram | 01/01/70 00:00 | |
| Just search for, "Relay" !! | 01/01/70 00:00 | |
| andy Neil | 01/01/70 00:00 | |
| Relay ratings | 01/01/70 00:00 | |
| ULN2803,ULN2003 | 01/01/70 00:00 | |
| more on relay ratings | 01/01/70 00:00 | |
| Yes of course | 01/01/70 00:00 | |
| internal diodes | 01/01/70 00:00 | |
| ULN2003's doesn't easily burn | 01/01/70 00:00 | |
| Uce saturation voltage is rather high | 01/01/70 00:00 | |
| there is an alternative, search for it | 01/01/70 00:00 | |
| I agree | 01/01/70 00:00 | |
| That is bad design | 01/01/70 00:00 | |
| ULNs resist more... | 01/01/70 00:00 | |
| I would never suggest 74HC buffers for d | 01/01/70 00:00 | |
| Yes , you didn't | 01/01/70 00:00 | |
| I would like to see where that is, pleas | 01/01/70 00:00 | |
correct link | 01/01/70 00:00 | |
| Bad Design? | 01/01/70 00:00 | |
| naah | 01/01/70 00:00 | |
| Also depends on transistor speed | 01/01/70 00:00 | |
| valid issue, but not that, now another | 01/01/70 00:00 | |
| Indeed | 01/01/70 00:00 | |
| Serial | 01/01/70 00:00 | |
| How much current? | 01/01/70 00:00 | |
| allegro | 01/01/70 00:00 | |
| and infineon | 01/01/70 00:00 |