| ??? 09/29/05 12:13 Read: times |
#101710 - To verify that your programming ("burnin Responding to: ???'s previous message |
To verify that your programming ("burning" the flash) works, try runninmg "blinky" does it work?
then 1) 4k7 is way too high for a "flying lead" IIC bus, try 1k if your uC can sink 5ma (see darasheet). 2) recode your timings to make the speed, say, 1/10 of what it is right now and see what happens. Just some IC test leads I had bought. Solder it! I put a transistor and an LED on both the SDA and SCL so that I could see if anything was actually happening on the pins. a) that will kill the bus and b) your eyeballs can not follow a 100kHz blink. To verify that your programming ("burnin" the memory) works, try runninmg "blinky" does it work? Erik |
| Topic | Author | Date |
| Using IIC.ASM | 01/01/70 00:00 | |
| address, speed | 01/01/70 00:00 | |
| Yes | 01/01/70 00:00 | |
| two things | 01/01/70 00:00 | |
| Is HW I2C easier? | 01/01/70 00:00 | |
| That may have been true then, this is no | 01/01/70 00:00 | |
| Replies. | 01/01/70 00:00 | |
| Check SBCMON | 01/01/70 00:00 | |
| SBCMON | 01/01/70 00:00 | |
| try a serial memory | 01/01/70 00:00 | |
| let us try another tack | 01/01/70 00:00 | |
| another tack. | 01/01/70 00:00 | |
| you have created just about the worst co | 01/01/70 00:00 | |
| Worst conditions. | 01/01/70 00:00 | |
| oscilloscope | 01/01/70 00:00 | |
| oscilloscope | 01/01/70 00:00 | |
| To verify that your programming ("burnin | 01/01/70 00:00 | |
| verifying. | 01/01/70 00:00 | |
| Without a scope you are kind of stuck, s | 01/01/70 00:00 | |
Success. | 01/01/70 00:00 | |
| back to the roots | 01/01/70 00:00 | |
| Success. | 01/01/70 00:00 | |
| To Mike! | 01/01/70 00:00 | |
| Hello Mehdi | 01/01/70 00:00 | |
| Or... | 01/01/70 00:00 | |
| this is a bootleg, use the original | 01/01/70 00:00 | |
| i2cbits | 01/01/70 00:00 | |
| you may want to go here | 01/01/70 00:00 | |
| Clock width is only 2 uSec in IIC_ASM ex | 01/01/70 00:00 |