| ??? 07/22/05 09:33 Read: times |
#97790 - re: more info Responding to: ???'s previous message |
Jan Waclawek said:
What is the power source, the attached hardware, used software, device programer, what do you use for measurement....
Jan Waclawek I am using just a general power supply of 5V which I have tested using oscilloscope, attached hardware is just oscillator, 33pf capacitors, and RST pin capacitor and resistor.I have used assembly language, EMP11 programmer and offcourse multimeter to check the volatage. I am not attaching any load at the output. I am just measuring the voltage using multimeter and its not faulty :) Regards Umar |
| Topic | Author | Date |
| AT89C2051 assistance needed | 01/01/70 00:00 | |
| output load | 01/01/70 00:00 | |
| 1, 2 and here is 3 and 4 | 01/01/70 00:00 | |
and vice versa | 01/01/70 00:00 | |
| my crystal ball says... | 01/01/70 00:00 | |
| re: more info | 01/01/70 00:00 | |
| what Pins? | 01/01/70 00:00 | |
| re : what pins? | 01/01/70 00:00 | |
| Are you | 01/01/70 00:00 | |
| Reset, oscillator | 01/01/70 00:00 | |
| Software! | 01/01/70 00:00 | |
| re: software | 01/01/70 00:00 | |
| not for 5 seconds but | 01/01/70 00:00 | |
| When strange things happen..... | 01/01/70 00:00 | |
| mehndi !!! | 01/01/70 00:00 | |
| sorry Fir that | 01/01/70 00:00 | |
| Try this | 01/01/70 00:00 |