| ??? 03/31/07 04:05 Read: times |
#136259 - Some hints Responding to: ???'s previous message |
1. You must connect pull up resistor to output of TSOP 1738
2. Open the remote control, and check for crystal rating (when i was doing the same and not get the good result then i did this and it works). Mostly all RC5 remote controls uses 3010 encoder ic. The clock use for modulation by this ic is (Crystal speed) / 12 . So check if crystal is of 432 KHz then change it to 456KHz (near by ~456 also works). 3. There are variety of remotes in market, one will invert the transmission data and other will not. this happened with me. |
| Topic | Author | Date |
| RC5 REMOTE DECODING | 01/01/70 00:00 | |
| Search? | 01/01/70 00:00 | |
| Sorry | 01/01/70 00:00 | |
| RC5 decoding | 01/01/70 00:00 | |
| what about searching? | 01/01/70 00:00 | |
| Some hints | 01/01/70 00:00 | |
| Example code | 01/01/70 00:00 | |
RC5 Encoder program | 01/01/70 00:00 |