| ??? 11/28/05 23:26 Read: times |
#104301 - I would recommend you... Responding to: ???'s previous message |
I would switch to the AT89S2051 and use the isp tool from atmel:
http://www.atmel.com/dyn/produ...ol_id=2877 Have also a look at this thread to get some hardware tipps: http://www.8052.com/forum/read.phtml?id=103301 Kai |
| Topic | Author | Date |
| From PJRC board to breadboard? | 01/01/70 00:00 | |
| Go to www.pjrc.com again | 01/01/70 00:00 | |
| Building 89C2051 ICP on PJRC dev board | 01/01/70 00:00 | |
| I would recommend you... | 01/01/70 00:00 | |
| Atmel's ISP system | 01/01/70 00:00 | |
| Re | 01/01/70 00:00 | |
| Atmel's ISP system | 01/01/70 00:00 | |
| If it is either of those there is no com | 01/01/70 00:00 | |
| Breadboarding | 01/01/70 00:00 | |
| just be aware | 01/01/70 00:00 | |
| Breadboarding | 01/01/70 00:00 | |
| same restrictions | 01/01/70 00:00 | |
| What you need is a solid ground plane | 01/01/70 00:00 | |
a better solution often is to purchase a | 01/01/70 00:00 | |
| hex-file is needed | 01/01/70 00:00 | |
| Flat cable? | 01/01/70 00:00 | |
| Flat cable | 01/01/70 00:00 |