| ??? 10/05/05 19:28 Read: times |
#101990 - Cable Pinout Responding to: ???'s previous message |
Ok, so i need a transceiver and a cable. But if i am to make the cable or buy it what pins go where? Will i be able to use a cisco rollover cable, or just a straight through with a converter. Another question as well, does the 485 only use 2 pins on the Rj45, because there were only 2 voltage outputs like you said. |
| Topic | Author | Date |
| 8051 Stock Checker Machine | 01/01/70 00:00 | |
| try this | 01/01/70 00:00 | |
| Manual | 01/01/70 00:00 | |
| Voltage Results | 01/01/70 00:00 | |
| that's most likely 485 | 01/01/70 00:00 | |
| Cisco Rollover Cable | 01/01/70 00:00 | |
| Make my Own cable? | 01/01/70 00:00 | |
| no - and yes | 01/01/70 00:00 | |
| Cable Pinout | 01/01/70 00:00 | |
| Connect the pin that measure +400mV to 4 | 01/01/70 00:00 | |
| Ground | 01/01/70 00:00 | |
| There should be | 01/01/70 00:00 | |
| RE:Ground | 01/01/70 00:00 | |
sure you can, will it do any good? I dun | 01/01/70 00:00 |