| ??? 09/06/05 15:49 Read: times |
#100695 - BLDC motor, Gear tooth sensor, etc Responding to: ???'s previous message |
Next link shows motor stator position sensing with Hall sensors on a three phase Brushless DC motor.
It resembles what you are now making of. "Remote Laboratory for a Brushless DC Motor" http://www.ewh.ieee.org/soc/es/May2001/02/Begin.htm Next link shows gear tooth sensor that consists of a ferromagnetic gear, Hall (or magnetoresistive) sensor(s) and magnet. Geartooth Sensors http://www.magsensors.com/dir.html And last, introduction for other magnetic revolution sensors. "Rugged devices join the revolution in revolution" http://www.edn.com/article/CA90789.html Tsuneo |
| Topic | Author | Date |
| Triggering Hall Effect sensors | 01/01/70 00:00 | |
| Comparator | 01/01/70 00:00 | |
| Analog output? | 01/01/70 00:00 | |
| Nope. | 01/01/70 00:00 | |
| Little magnets | 01/01/70 00:00 | |
| Wow ! | 01/01/70 00:00 | |
| Nice link | 01/01/70 00:00 | |
| bar magnets? | 01/01/70 00:00 | |
| bar magnets | 01/01/70 00:00 | |
| Got the point, | 01/01/70 00:00 | |
| The earth magnetism | 01/01/70 00:00 | |
| Made it work ! | 01/01/70 00:00 | |
| BLDC motor, Gear tooth sensor, etc | 01/01/70 00:00 | |
| Geartooth sensors good ;) | 01/01/70 00:00 | |
| Analog output? | 01/01/70 00:00 | |
| speaker magnets | 01/01/70 00:00 | |
| Ditto that | 01/01/70 00:00 | |
| Flux | 01/01/70 00:00 | |
| C like motor magnets | 01/01/70 00:00 | |
| Open-Collector output | 01/01/70 00:00 | |
| I did | 01/01/70 00:00 | |
| How to attach more than one magnet | 01/01/70 00:00 | |
| symmetric placement | 01/01/70 00:00 | |
| photo coupler | 01/01/70 00:00 | |
| Measuring RPM - the software side | 01/01/70 00:00 | |
| Timing routines are alright | 01/01/70 00:00 | |
| Unipolar vs bipolar sensors | 01/01/70 00:00 | |
| try here | 01/01/70 00:00 | |
Thanks for your contribution erik | 01/01/70 00:00 |