Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
07/18/11 08:48
Read: times


 		 #182879 - Make It Like...
Responding to: ???'s previous message
Make your "jumper pad" like this figure. This will make it much much easier to bridge solder across the gap.



Michael Karas


List of 43 messages in thread
TopicAuthorDate
PAD as Jumper            01/01/70 00:00      
   Make It Like...            01/01/70 00:00      
      Snake eating snake ;)            01/01/70 00:00      
   Constructing a component..            01/01/70 00:00      
      clue needed            01/01/70 00:00      
         Altium designer forum            01/01/70 00:00      
         Component            01/01/70 00:00      
            The "Component" has 2 pads.            01/01/70 00:00      
               It is quite common ...            01/01/70 00:00      
                  Common practice, ...            01/01/70 00:00      
                     perspective?            01/01/70 00:00      
                        My perspective            01/01/70 00:00      
                           fine table, i just have to add            01/01/70 00:00      
                              technically proficient installers            01/01/70 00:00      
                                 That is not how I think            01/01/70 00:00      
                                    A soldier jump            01/01/70 00:00      
                                 Not for field configuration            01/01/70 00:00      
                                    But Dev Boards            01/01/70 00:00      
                                       RE: But Dev Boards            01/01/70 00:00      
   Another possibility to consider....            01/01/70 00:00      
   Some other ideas from the web            01/01/70 00:00      
      that final picture            01/01/70 00:00      
         original page reference            01/01/70 00:00      
            Another Example Linking Picture            01/01/70 00:00      
               I get the red box again!            01/01/70 00:00      
                  Red Box Indeed...            01/01/70 00:00      
                  Trivial setting, but sometimes quite needed            01/01/70 00:00      
      Going the other way            01/01/70 00:00      
         Removing a Link            01/01/70 00:00      
            You misunderstand            01/01/70 00:00      
               I did misunderstand....            01/01/70 00:00      
      The Whole Point...            01/01/70 00:00      
   PAD as Jumper            01/01/70 00:00      
      Narrow, pointy bits            01/01/70 00:00      
      Isn't that a touch sensor?            01/01/70 00:00      
         PAD as jumper            01/01/70 00:00      
            same comment            01/01/70 00:00      
            Use This            01/01/70 00:00      
               PAD as Jumper            01/01/70 00:00      
                  Narrow Gap            01/01/70 00:00      
   PAD as Jumper/Short link            01/01/70 00:00      
      What "problem" ?            01/01/70 00:00      
      CAD software has lots of primitives            01/01/70 00:00      

Back to Subject List