| ??? 07/28/10 10:41 Read: times |
#177498 - Avoid steep filters if ou can Responding to: ???'s previous message |
If you need to capture 400Hz signals, I'm not so sure 1kHz is a good sampling rate.
You should have a low-pass filter to handle signals above 50% of the sampling rate, but with a larger margin between highest frequency you want to capture and the sampling rate you don't need so steep filter. |
| Topic | Author | Date |
| Digital Signal Processor/Controller novice tips.. | 01/01/70 00:00 | |
| EMG ? | 01/01/70 00:00 | |
| EMG | 01/01/70 00:00 | |
| Correct | 01/01/70 00:00 | |
| perhaps a little more detail would help | 01/01/70 00:00 | |
| ARM is a good place to start. | 01/01/70 00:00 | |
| dspic scary? | 01/01/70 00:00 | |
| not always "the plan" | 01/01/70 00:00 | |
| SiLabs has something ... | 01/01/70 00:00 | |
| The Type of Signal.. | 01/01/70 00:00 | |
| 0-10mV | 01/01/70 00:00 | |
| 0-10mV in 8051 | 01/01/70 00:00 | |
| Avoid steep filters if ou can | 01/01/70 00:00 | |
| Following Nyquist is the bare minimum | 01/01/70 00:00 | |
| Aliasing | 01/01/70 00:00 | |
Think about this some more ... | 01/01/70 00:00 |