Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
06/06/10 17:13
Read: times


 		 #176451 - Per forgot
Responding to: ???'s previous message
that you must supply 20mA AND whatever your 'receiving' device uses itself.

I would, to be sure, go by the 34mA current limit plus the 5mA for the 'receiver'.

NOTE: your device need to 'function' i.e. not burn and give max reading on a short and minimum reading on an open, after all this is industrial.

Erik

List of 33 messages in thread
TopicAuthorDate
DC / DC Convertor            01/01/70 00:00      
   OK            01/01/70 00:00      
   that is not possible            01/01/70 00:00      
      Clarification            01/01/70 00:00      
         Select 9-12V with a capacity to supply up to 20mA            01/01/70 00:00      
            I think I see what is needed            01/01/70 00:00      
               Per forgot            01/01/70 00:00      
                  Incorrect....            01/01/70 00:00      
                     incorrect?            01/01/70 00:00      
   Getting power from the USB port            01/01/70 00:00      
      OK for Development            01/01/70 00:00      
         Required points clarified - thanks            01/01/70 00:00      
            trying again            01/01/70 00:00      
         re: OK?            01/01/70 00:00      
            The Curse Of Stuff That "Works" (sic)            01/01/70 00:00      
               USB has provisions for 1.8A from charger ports            01/01/70 00:00      
         I should know better, word of warning            01/01/70 00:00      
            Worse :(            01/01/70 00:00      
               Fuse?            01/01/70 00:00      
                  With picture            01/01/70 00:00      
                     And the external USB connectors?            01/01/70 00:00      
                     Is that really a PC motherboard?!            01/01/70 00:00      
                        Unusual USB connector.            01/01/70 00:00      
                           It all looks a bit "chunky"...            01/01/70 00:00      
                        It's a front panel board            01/01/70 00:00      
                     Both Ports??            01/01/70 00:00      
                        Yes, both ports            01/01/70 00:00      
                           Fusing S/B on main board            01/01/70 00:00      
                           Poor C6...            01/01/70 00:00      
               Bolt that stable door!            01/01/70 00:00      
      Really?            01/01/70 00:00      
         Standby?            01/01/70 00:00      
      RE: Getting power from the USB            01/01/70 00:00      

Back to Subject List