| ??? 04/24/06 18:21 Read: times |
#114922 - I would imagine that designing something Responding to: ???'s previous message |
The problem tends to be these gauges are truly, truly awful and show empty from about 1/2 full,
I said If a gas gauge is correct when close to empty The point I'm trying to make is that if your design gives a fairly accurate reading between 1/4 and 0 the rest can be +-10% with no harm. I would imagine that designing something that is reasonably precise in the "lower curve" and is allowed to be imprecise in the "upper curve" would be a lot easier than trying to match both "curves" Erik |
| Topic | Author | Date |
| Weekend off topic and My homework | 01/01/70 00:00 | |
| one would imagine ... | 01/01/70 00:00 | |
| Simplest | 01/01/70 00:00 | |
| a memory old enough to be carbon dated : | 01/01/70 00:00 | |
| near enough | 01/01/70 00:00 | |
| Dang... He took all the fun out of it. | 01/01/70 00:00 | |
| Not Quite | 01/01/70 00:00 | |
| Oh yea, right | 01/01/70 00:00 | |
| HUH | 01/01/70 00:00 | |
| Pure cosine? | 01/01/70 00:00 | |
| Granted | 01/01/70 00:00 | |
| Bending of curve | 01/01/70 00:00 | |
| Good ideas | 01/01/70 00:00 | |
| Yes, but only if totaly empty! | 01/01/70 00:00 | |
| LPG | 01/01/70 00:00 | |
LPG | 01/01/70 00:00 | |
| who gives a s... about precision | 01/01/70 00:00 | |
| Inaccuracy | 01/01/70 00:00 | |
| I would imagine that designing something | 01/01/70 00:00 | |
| Analogue | 01/01/70 00:00 | |
| Sketch! | 01/01/70 00:00 | |
| Arm | 01/01/70 00:00 |