| ??? 03/15/05 09:26 Read: times |
#89703 - NOT Halleffect Responding to: ???'s previous message |
The sensor you have is a reluctor, not a Hall sensor, like Russell says. If you can fit a Hall switch, you might be better off, or perhaps a small pick-off coil wrapped on a toroid with an ignition lead running thorugh the middle. If you have to, then run the existing signal through an LM311 comparator, but be careful with noise and thresholds.
Steve |
| Topic | Author | Date |
| Hall Effect Sensor | 01/01/70 00:00 | |
| Subject Circuit | 01/01/70 00:00 | |
| why tap into the ignition interface? | 01/01/70 00:00 | |
| Spare Spark | 01/01/70 00:00 | |
| divide by two? | 01/01/70 00:00 | |
| Wasted Spark | 01/01/70 00:00 | |
| Spare/wasted | 01/01/70 00:00 | |
| nomenclature | 01/01/70 00:00 | |
| Hall Effect? | 01/01/70 00:00 | |
IR | 01/01/70 00:00 | |
| NOT Halleffect | 01/01/70 00:00 | |
| Sniffing spark | 01/01/70 00:00 | |
| Hall Effect Sensor Help | 01/01/70 00:00 | |
| Thanks | 01/01/70 00:00 | |
| Schematic | 01/01/70 00:00 | |
| Decreasing 1M resistance | 01/01/70 00:00 | |
| Different approach | 01/01/70 00:00 | |
| 18Vpp or 18Vp? | 01/01/70 00:00 | |
| Correcting of typing error | 01/01/70 00:00 | |
| Re: Typing error | 01/01/70 00:00 | |
| Some comments | 01/01/70 00:00 |