| ??? 01/05/06 21:22 Read: times |
#106640 - Command Termination Responding to: ???'s previous message |
Rajeev Arora said:
The problem I am facing is that after sending the AT\n\r command to the mobile my mobile does not give back the command's recognition Usually, AT command require just CR (Carriage Return, \r) - maybe the LF (Line Feed, \n) is confusing it? Again, you could check this with a terminal (or terminal emulator). Have you tried searching the Nokia site (and elsewhere) for a technical manual? Unfortunately, technical information for consumer products like this is often hard (or impossible) to find :-( - but you should at least try. For this reason, if this is a commercial project, you may be better to consider using a properly-supported GSM modem, rather than a phone: http://www.8052.com/forum/read.phtml?id=101998 The Phone should comply with the standard GSM AT Command Specs - see the 07-Series specs: ftp://ftp.3gpp.org/specs/latest/Ph2/07_series/ 07.07 - AT command set for GSM Mobile Equipment 07.05 - Short Message Service (SMS) and Cell Broadcast Service (CBS) |
| Topic | Author | Date |
| Connecting Nokia 6610i and 8051by ATCom | 01/01/70 00:00 | |
| terminal on PC | 01/01/70 00:00 | |
| 6610i and 8051 | 01/01/70 00:00 | |
| Check with terminal on PC | 01/01/70 00:00 | |
| Command Termination | 01/01/70 00:00 | |
| try forum.nokia.com | 01/01/70 00:00 | |
| ATCommand on Hyper Terminal works fine | 01/01/70 00:00 | |
| Re. ATCOMMAND | 01/01/70 00:00 | |
| Line termination | 01/01/70 00:00 | |
| Nokia F-Bus Protocol. | 01/01/70 00:00 | |
Is this relevant? | 01/01/70 00:00 |