| ??? 01/04/06 18:21 Read: times |
#106486 - You mean the Simulator? Responding to: ???'s previous message |
Suyash Shembekar said:
my code is working fine in a keil's (IDE) debugger Do you mean the simulator? but when I run the same code on actual H/W, the dedicated portpins are not going High/Low as per the requirement. How have you tested this - with an oscilloscope? Are pullup resistors required? Does any of your code run in the target - is it just the SPI, or does the whole thing just not run at all? |
| Topic | Author | Date |
| ADC with SPI | 01/01/70 00:00 | |
| What tell the datasheets? | 01/01/70 00:00 | |
| It dosen't work in hardware | 01/01/70 00:00 | |
| SPI standard | 01/01/70 00:00 | |
| Which flags? | 01/01/70 00:00 | |
| You mean the Simulator? | 01/01/70 00:00 | |
Try this | 01/01/70 00:00 | |
| The MCP3208 data sheet to | 01/01/70 00:00 |