| ??? 12/16/05 19:28 Read: times |
#105419 - It was configured earlier.. Responding to: ???'s previous message |
I am working on a code which has been developed earlier.....I kind of overlooked the port configuration initially. Now I have configure the RXD(P1.1) = input and TXD(P1.0) = Push-pull and the serial communication seems to be working.....
But as Erik said: likely, but not certain, anthow it will not work. It may damage both the uC and the transceiver. The real problem with things like this is that it may weaken a part of a chip which you can not detect, thus creating a problem that will not show up till later. I might encounter problems later in the project.... Thanks, Shruthi |
| Topic | Author | Date |
| port RX and TX | 01/01/70 00:00 | |
| if you use CodeAtchitect, is that not wh | 01/01/70 00:00 | |
| RXD push pull | 01/01/70 00:00 | |
| it might,. depends on what is connected | 01/01/70 00:00 | |
| Not the reason | 01/01/70 00:00 | |
| He did think | 01/01/70 00:00 | |
| thanks | 01/01/70 00:00 | |
| likely, but not certain, anthow it will | 01/01/70 00:00 | |
| Sorry! | 01/01/70 00:00 | |
| MAX 232 IC | 01/01/70 00:00 | |
| Why push-pull? | 01/01/70 00:00 | |
| It was configured earlier.. | 01/01/70 00:00 | |
| Well done! | 01/01/70 00:00 | |
| Max232 and its 5V | 01/01/70 00:00 | |
| Then only input-only configuration | 01/01/70 00:00 | |
| Thanks!! | 01/01/70 00:00 | |
| Good luck! | 01/01/70 00:00 | |
| Quoting replies | 01/01/70 00:00 | |
thanks | 01/01/70 00:00 |