| ??? 11/24/05 13:39 Read: times |
#104116 - hmmm..but Responding to: ???'s previous message |
thanks for suggestion abhishek,
Abhishek Singh said:
using a pin as o/p and then CLR P1.5 ; start motor testing it as an input is not recomanded JNB P1.5,HERE1 Abee BUT, i am not testing it as input, infact this Pin 1.5 is cleared in the interrupt service routine by the software when cycle count is completed , so I do not see this as problem infact motor starts and stops perfectly fine with Pin 1.5, I am testing pin 3.4(T0) as input from the magnetic pulse generator. |
| Topic | Author | Date |
| C2051 & Magnetic pulse generator | 01/01/70 00:00 | |
| either i or o | 01/01/70 00:00 | |
| hmmm..but | 01/01/70 00:00 | |
| Debug suggestions | 01/01/70 00:00 | |
| Software Debounce | 01/01/70 00:00 | |
| magnetic pick up tachometers experiences | 01/01/70 00:00 | |
| RE: magnetic pickup tachometer | 01/01/70 00:00 | |
| RS482 - Typo? | 01/01/70 00:00 | |
| darn thumbs | 01/01/70 00:00 | |
| This could be the reason... | 01/01/70 00:00 | |
| bufer amp | 01/01/70 00:00 | |
| why the UG? | 01/01/70 00:00 | |
| pc scopes | 01/01/70 00:00 | |
| could you | 01/01/70 00:00 | |
| What tells the oscilloscope? | 01/01/70 00:00 | |
| Build simple test tools to fix your unit | 01/01/70 00:00 | |
| Excessive rise times during startup? | 01/01/70 00:00 | |
| Good, but even better would be | 01/01/70 00:00 | |
| Full story | 01/01/70 00:00 | |
| thanks, so can I... | 01/01/70 00:00 | |
| yes, if and only if the channel A | 01/01/70 00:00 | |
| cheerz | 01/01/70 00:00 | |
| Time bomb.. | 01/01/70 00:00 | |
| Perhaps a little explanation? | 01/01/70 00:00 | |
| setting the hysteresis | 01/01/70 00:00 | |
Thank, Erik! | 01/01/70 00:00 |