| ??? 10/10/05 14:07 Read: times |
#102172 - The precision is depending on the fracti Responding to: ???'s previous message |
So here I am unable to understand whether using higher frequency will reduce the error or using lower frequency and also how is this percentage derived?
The precision is depending on the fraction of a second that n clock ticks is being a whole number. The clock speed magnitiude is irrelevant (if not "ridiculous") There are "tricks" ti make a clock precise even if that is not the case, anyhow a SW based RTC is not a good idea, everything will be switched off now and then e.g battery change. Erik |
| Topic | Author | Date |
| Software Based RTC | 01/01/70 00:00 | |
| Context | 01/01/70 00:00 | |
| Link to my RTC - sftware crystal freq. | 01/01/70 00:00 | |
| The precision is depending on the fracti | 01/01/70 00:00 | |
| How to count seconds | 01/01/70 00:00 | |
| How to decide count for a 3.5795Mhz, | 01/01/70 00:00 | |
| the frequency range does not matter | 01/01/70 00:00 | |
| the "tricks" | 01/01/70 00:00 | |
| 3.93216MHz is better | 01/01/70 00:00 | |
| 4.915200 | 01/01/70 00:00 | |
| 3.93216 ?? | 01/01/70 00:00 | |
| 3.93216 is standard frequency | 01/01/70 00:00 | |
| Can i have some clarifications on XTALS | 01/01/70 00:00 | |
| manufacturing tolerances | 01/01/70 00:00 | |
| low frequencies Crystals are bigger ? | 01/01/70 00:00 | |
| 32.768kHz means low current consumption | 01/01/70 00:00 | |
| so higher Frequeny crystals are accurate | 01/01/70 00:00 | |
Yes! | 01/01/70 00:00 | |
| The Right Frequency | 01/01/70 00:00 |