| ??? 09/22/05 21:45 Read: times |
#101410 - ad7710 Responding to: ???'s previous message |
Dear Erik,
Thanks for comment. It is assembled on a two layers metalized pcb with grounded polygone. There is no wire connection or prototype ones. I guess, I need a calibration routin after start up. Till no, i can't drive its calibration commands so it described in its datasheet. Also, I cant find in its datasheet details for reading calibrastion registers! As its recommended basic circuit, i shorted /sync pin to +5V and mode pin to GND. navid |
| Topic | Author | Date |
| ad7710 question | 01/01/70 00:00 | |
| Check the obvious | 01/01/70 00:00 | |
| ad7710 | 01/01/70 00:00 | |
| It sounds like you are "prototyping". I | 01/01/70 00:00 | |
| ad7710 | 01/01/70 00:00 | |
calibratin commands | 01/01/70 00:00 |